Tips For The Installation Of Recessed Lighting

If you want a good lighting wherever you live, then choosing recessed lighting in Orange County is the appropriate choice. This is because they would provide a very neat look in any kind of environment and they will likewise enhance the brightness of your environment. In addition to that there are various kinds of recessed lighting, which are available in San Diego.

 

What You Need to Begin Recessed Lighting Installation

Recessed lighting installation in Orange County is very easy, even if you have dropped a ceiling or can get above it; it is also possible to install recessed fixtures. The installation can be tricky whenever you do not have any access to the ceiling, but the good thing is that most of the manufacturers of quality recessed lighting in Riversideoffer remodeling fixtures. These fixtures would then be installed below the ceiling.

The other thing which you need to consider during recessed lighting installation in Orange County is whether the power source is near. If there is a ceiling box where you want your light, you will disconnect the wires from the box so that you will be able to reattach them to the fixture. The recessed lighting in Riverside will likewise come already wired to their junction box. All that is required of you is to cut a circular hole in the ceiling and attach the lead wires to the box junction; you can then start sliding the fixture up into the ceiling until the fixture mounts.

Safety Issues Involved With Installing Recessed Lights

If the insulation makes contact with a poorly rated recessed light fixture, it could result to a fire. That’s the main reason why it is recommended to get an insulation-contact fixture. Also, if you run a cable into a new box junction and then to the light, you must place the junction box perfectly to the basement or attic. If it is covered with something, it would not work.

Steps in the installation of Recessed Lighting

Cut an opening and start wiring the light, turn the power to the house off before starting the process. You can also have an electronic stud finder handy so that you can easily locate the ceiling joint. Make an outline of the fixture on the ceiling. Now, you need to ensure you have a tarp beneath you. Use a drywall saw to cut a new opening or enlarge the existing one for the recessed light between the joists. While you are doing this, ensure that no cable is cut in the process. Put in an electric cable into the junction box and then make sure you tighten it with a cable clamp. Strip the wires if such is needed and then connect them to the fixture with wire connectors. Now, you can start connecting the fixture’s dark wire to the dark house wire, then ground to ground and white to white. You can then place the wires inside the box and fasten the cover.

After that you need to install the fixture housing, and then start turning the fixture into the appropriate place in the ceiling until it is properly placed in position. The fixture and its junction box are both very light, so you would not need to secure the junction box to a joist.

 

Articles For Website
Logo
Enable registration in settings - general