Get it into this, which is basically a slot on a NANO Mini GPS Tracker will be a problem. But not like that. So we’ll make this
Mini GPS Tracker smaller to fit it here. So let’s go after that. Let’s see if it fits here.
If not, we’ll grind it. I think that’s fine. Before we begin, we need to turn off the PIN code on the SIM card. So let’s turn it off. Now we have turned off the PIN code on the SIM card. We pull out the SIM card. So we turned off the PIN code on the SIM card. Now we will try to insert it into the GPS Locator. So here it is we see that two leds light up, blue, Green.
According to the manual, it is connected to the voltage from the scooter’s battery. Here is a list of commas which we can set up over the phone. We can close this. We will connect the power connector. Let’s measure how much current this Locator draws current. It is up to 50 mas. It is now at rest. In this state, it should be around 20 mas. After about five minutes. We will extend these cables, . At the ends we press the cable lugs. So we have it ready. We have the wires extended, they hold! We can go mount it on the scooter. We opened all the covers on the scooter in advance. Now we’re going to connect it to the battery, to the plus, to the minus. We connect minus first. . Then plus we should do this.
We will also install a cover. Now we will attach the GPS itself to the construction of the scooter. So let’s take a look at what it looks like in the application. We installed Untrack. We will open the application. Here we can actually see the scooter. It is currently close to the house. We can also measure how many meters it is as the crow flies from the house. Next we can change the map to satellite. This bar shows status means that the scooter is in motion. GPS Locator connected, The GSM signal is strong, battery voltage, 15.1V so it charges. Time. Date, 5.4.2021, 14:19, Current speed 24km / h Northbound Address. When we click on more. We will find the history of rides there. Here we say, say, the second of April. We press play. Here he shows us. Depicts where the scooter moved. Mini GPS Tracker can also be accelerated Shifted. Let’s take a break; here we can also see the details. Then we have Geophone, it is actually a boundary that will alert us when we cross it. If we enter the bottom or outside.
We have this set up at home. It’s within 100 meters, a message beeped a while ago, that the scooter entered this protective area. If we have a phone number set up, we will also receive an SMS message there. There is even more. Send commas, here you can scooter ARM, or DISARM. When you set your main phone number, so you will receive SMS messages. Upload Frequency, I have set every 5 seconds. Set the time zone according to the time zone you live in. Vibration sensitivity, by setting the sensitivity you can get messages, in case someone kicks you in the scooter. Finally, restoring the factory settings. Device info, we can see the device information. You can change the password here. The default password is always set on the device from the factory. Change skin, you can change the look of the home screen. Instructions, these are only in Chinese, so it won’t help us much.
